Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
♦ Connecting Pin -T10027 A-
Adjustment Requirements
• Operating and transfer elements of shift mechanism must be
in proper condition.
• Shift mechanism must move freely.
• The transmission, clutch and clutch mechanism must be in
proper condition.
• Transmission in neutral position.
Adjusting
– Open the ashtray.
– Carefully pry trim from center console -arrows-.
– Lift trim up over shift knob.
– Move the shift lever in the neutral position toward the left into
the 1st/2nd gear shift gate.
– Lift the noise insulation plate.
– Guide the -T10027A- through hole -A- and into hole -B-.
Note
To improve clarity, the noise insulation is removed in the figure.
– Completely remove the air filter housing. Refer to ⇒ Fuel In‐
jection and Ignition; Rep. Gr. 24 ; Removal and Installation .
Audi TT 2007 ➤
Manual Transmission - Edition 10.2009
70 Rep. Gr.34 - Controls, Housing
To Next Page
Loading...
