Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
– Fill area between sealing lip and dust lip -arrow- halfway with
sealing grease -G 052 128 A1- .
– Drive in sealing ring to stop using -T10049- .
– Install right flange shaft. Refer to
⇒ “3.4 Right Flange Shaft”, page 230 .
– Check the transmission oil level in the bevel box and replenish.
Refer to
⇒ “1.1 Manual Transmission, Checking Gear Oil Level”, page
47 .
3.6 Right Flange Shaft Needle Bearing
Special tools and workshop equipment required
♦ Thrust Plate -VW 401-
♦ Thrust Plate -VW 402-
♦ Punch -VW 407-
♦ Thrust Disc -VW 412-
♦ Alignment Fixture -VAS 3253-
♦ Assembly Tool -T10047-
Procedure
– Remove right flange shaft. Refer to
⇒ “3.4 Right Flange Shaft”, page 230 .
– Mount the -T10047- as illustrated.
• The markings B on both parts face each other
• The sections -arrows- must then be located under the bearing.
– Bolt the parts together.
Audi TT 2007 ➤
Manual Transmission - Edition 10.2009
232 Rep. Gr.39 - Final Drive, Differential
To Next Page
Loading...
