Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
12 - Securing Ring
13 - Needle Bearing
❑ For 6th gear
14 - 6th Gear Selector Gear
15 - Synchronizer Ring for 6th Gear
❑ Checking for wear ⇒ page 205
16 - Locking Sleeve with Synchronizer Hub for 5th and 6th Gears
❑ After removing circlip -17-, press off gear wheel for 6th gear ⇒ page 203 .
❑ Disassembling ⇒ page 205
❑ Assembling operating sleeve/synchronizer hub ⇒ page 205 and ⇒ page 206
❑ Pressing on ⇒ page 206
17 - Securing Ring
18 - Needle Bearing
❑ For 5th gear
19 - Synchronizer Ring for 5th Gear
❑ Checking for wear ⇒ page 205
20 - 5th Gear Selector Gear
21 - Tapered Roller Bearing Inner Race
❑ Pulling off ⇒ page 203
❑ Pressing on ⇒ page 206
22 - Securing Ring
❑ When replacing tapered roller bearing -21- and output shaft -5-, determine again ⇒ page 206
23 - Taper Roller Bearing Outer Race
❑ Pulling out ⇒ page 207
❑ Installing ⇒ page 207
24 - Adjustment Shim
❑ Determining thickness, refer to
⇒ “2.5 Output Shaft for 5th/6th Gear and Reverse Gear, Adjusting”, page 188
25 - Transmission Housing
26 - Spring
❑ Installation location ⇒ page 206
27 - Locking Collar
28 - Synchronizer Hub
29 - Locking Pieces (quantity: 3)
❑ Installation location ⇒ page 205
2.5 Output Shaft for 5th/6th Gear and Re‐
verse Gear, Adjusting
A new output shaft adjustment is required when the following
components have been replaced:
♦ Transmission housing
♦ Clutch housing
♦ Output shaft 5th/6th gear/reverse gear
♦ Tapered roller bearing for output shaft
Audi TT 2007 ➤
Manual Transmission - Edition 10.2009
188 Rep. Gr.35 - Gears, Shafts
To Next Page
Loading...
