Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
– Secure -VW 771/40- in threaded hole of transmission housing
as depicted in the illustration.
– Secure the transmission on the -3282- using bolt M10x20
-A-.
– Remove last lower engine/transmission connecting bolts
-1 to 3-.
– Press transmission off of engine and turn upward in differential
area. Guide the transmission past driveshaft -A- and front ex‐
haust pipe -B- with output flange -C-. Rotate the output flange
if necessary.
Note
Also note area between bevel box and intermediate plate/engine.
– Press off transmission from alignment sleeves.
– Carefully lower transmission.
Note
Pay attention to electromechanical steering gear when lowering
the transmission.
4.5 Transmission, Transporting
Special tools and workshop equipment required
♦ Transmission Support Jig -3336-
♦ Shop Crane -VAS 6100-
Audi TT 2007 ➤
Manual Transmission - Edition 10.2009
106 Rep. Gr.34 - Controls, Housing
To Next Page
Loading...
