Audi TT 2007 - Luk Clutch Assembly Overview

Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
2.6 LuK Clutch Assembly Overview
Note
Dual-mass flywheel, pressure plate and clutch plate are allocated to each other and must not be mixed with
other manufacturer's components.
1 - Dual-Mass Flywheel
❑ Removing and instal‐
ling, refer to ⇒ Engine
Mechanical; Rep. Gr.
13 ; Removal and Instal‐
lation
❑ Make sure centering
pins fit securely
❑ Contact surface for
clutch lining must be
free of grooves, oil and
grease
❑ Observe removal in‐
structions ⇒ page 27
2 - Clutch Plate
❑ Removing and instal‐
ling, refer to
⇒ “4.9 LuK Clutch”,
page 42
❑ Only replace together
with SAC pressure plate
❑ Installation position: the
transmission side label
faces the transmission
❑ Clutch plate diameter,
refer to the electronic
parts catalog ETKA
3 - SAC Pressure Plate
❑ SAC = Self Adjusting
Clutch
❑ Only replace together
with clutch plate
❑ Removing and instal‐
ling, refer to
⇒ “4.9 LuK Clutch”,
page 42
❑ Check the adjusting ring position in the case of a new SAC pressure plate ⇒ page 44
❑ Checking ends of the diaphragm spring ⇒ page 23
❑ Check spring connection and rivet connections ⇒ page 26
❑ Check the metal ring ⇒ page 26
❑ Contact surface for clutch lining must be free of grooves, oil and grease
4 -
Bolt
❑ M6 - 13 Nm
❑ M7 - 20 Nm
❑ Loosen and tighten one after another in 90° increments
Audi TT 2007 ➤
Manual Transmission - Edition 10.2009
2. Description and Operation 25