Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
Checking Ends of the Diaphragm Spring
• Wear up to half the thickness of the diaphragm spring
-arrows- is permitted.
Checking the Pull-Springs and Rivet Connection
I - Pull-springs OK
• Slight offset in the outer area -arrows A-.
II - Pull-springs damaged
• The pressure plate must be replaced if the pull-spring is bent
or broken off -arrow B-.
– Make sure the rivet connections -arrows B- fit correctly on all
pull-springs -A-.
• Replace any pressure plates that have loose rivet connections
-arrow B-.
Checking Metal Ring
– Check the metal ring inside the pressure plate for damage
-arrow-.
• Replace any pressure plates that have a broken metal ring.
Audi TT 2007 ➤
Manual Transmission - Edition 10.2009
26 Rep. Gr.30 - Clutch
To Next Page
Loading...
