Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
– Press clutch master cylinder actuator rod -1- in direction of the
-arrow- until mounting clip -2- engages audibly in the clutch
pedal.
– Install mounting bracket. Refer to
⇒ “4.4 Mounting Bracket”, page 34 .
4.7 Slave Cylinder with Release Bearing
Note
Slave cylinder and release bearing are one unit and can only be
replaced together.
Removing
• Transmission removed, refer to
⇒ “4.4 Transmission, Removing”, page 96 .
– Release securing clip -2- with a screwdriver and pull off bleed‐
er -4- from clutch slave cylinder -1-.
– Remove bolts -arrows-.
– Remove the clutch slave cylinder together with release bear‐
ing -A-.
Installing
• Tightening specification, refer to
⇒ “2.4 Clutch Release Mechanism, Clutch Slave Cylinder As‐
sembly Overview”, page 21 .
Install in reverse order, paying attention to the following:
Caution
The clutch slave cylinder bolts may only be tightened in small
increments. Otherwise, there is the danger that the mounting
tabs -arrows- could break off.
– Tighten the clutch slave cylinder with the release bearing
-arrows-.
Audi TT 2007 ➤
Manual Transmission - Edition 10.2009
4. Removal and Installation 39
To Next Page
Loading...
