Audi TT 2007 - Page 44

Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
– Place a spacer -A- between the clutch pedal and the stop and
press the clutch pedal forward.
•
Length of spacer = approximately 40 mm (for example
1
/
2
"
socket insert)
– Release retaining clip -B- and pull the clutch master cylinder
out of the bearing bracket -arrow 1- and -arrow 2-.
Installing
• Move clutch pedal up to stop in rest position.
– Attach mounting clip -2- to clutch master cylinder actuator rod
-1-.
– Place a spacer -A- between the clutch pedal and the stop and
press the clutch pedal forward.
•
Length of spacer = approximately 40 mm (for example
1
/
2
"
socket insert)
– Secure the clutch master cylinder on the bearing bracket
-arrow 1- and -arrow 2-.
Audi TT 2007 ➤
Manual Transmission - Edition 10.2009
38 Rep. Gr.30 - Clutch