Audi TT 2007 - Shift Knob and Covers Assembly Overview

Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
2.2 Shift Knob and Covers Assembly Overview
1 - Shift Knob with Shift Lever
Boot
❑ Cannot be separated
from each other
❑ Replace together
❑ Removing and instal‐
ling, refer to
⇒ “4.1 Shift Knob with
Shift Lever Boot”,
page 90
❑ Disconnecting from
center console cover
⇒ page 55
❑ Disconnecting from
mounting frame
⇒ page 55
2 - Clamp
❑ To secure shift knob on
shift lever
❑ Securing with hose clip
pliers -V.A.G 1275-
3 - Center Console Trim
❑ Removing and installing
together with shift knob,
refer to
⇒ “4.1 Shift Knob with
Shift Lever Boot”,
page 90
❑ Disconnecting from shift
lever boot ⇒ page 55
4 - Mounting Frame
❑ Disconnecting from
center console
⇒ page 55
❑ Disconnecting from shift
lever boot ⇒ page 55
5 - Washer
❑ Quantity: 4
6 - Bolt
❑ 1.5 Nm
❑ Quantity: 4
7 - Noise Insulation Plate
8 - Noise Insulation
9 - Selector Lever
❑ Adjusting selector mechanism, refer to ⇒ “2.8 Shift Mechanism, Adjusting”, page 69
Audi TT 2007 ➤
Manual Transmission - Edition 10.2009
54 Rep. Gr.34 - Controls, Housing