Audi TT 2007 - Sachs Clutch Assembly Overview

Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
❑ Removing and installing, refer to ⇒ “4.1 Hose/Line Assembly or Plastic Line”, page 29
9 - O-ring
❑ Replace if damaged
❑ Pull onto line connection
❑ Install with brake fluid
10 - Bleeder
❑ Removing and installing, refer to ⇒ “4.7 Slave Cylinder with Release Bearing”, page 39
11 - Shaft Seal
❑ For input shaft
❑ Removing and installing, refer to ⇒ “4.13 Input Shaft Seal”, page 123
2.5 Sachs Clutch Assembly Overview
Note
Dual-mass flywheel, pressure plate and clutch plate are allocated to each other and must not be mixed with
other manufacturer's components.
1 - Dual-Mass Flywheel
❑ Removing and instal‐
ling, refer to ⇒ Engine
Mechanical; Rep. Gr.
13 ; Removal and Instal‐
lation
❑ Make sure centering
pins fit securely
❑ Contact surface for
clutch lining must be
free of grooves, oil and
grease
❑ Observe removal in‐
structions ⇒ page 24
2 - Clutch Plate
❑ Removing and instal‐
ling, refer to
⇒ “4.8 Sachs Clutch”,
page 40
❑ Only replace together
with pressure plate
❑ Installation location
⇒ page 41
❑ Clutch plate diameter,
refer to the electronic
parts catalog ETKA
3 - Pressure Plate
❑ With adjustment mech‐
anism
❑ Identification
⇒ page 23
❑ Removing and instal‐
ling, refer to
⇒ “4.8 Sachs Clutch”,
page 40
❑ Checking ends of the diaphragm spring ⇒ page 23
Audi TT 2007 ➤
Manual Transmission - Edition 10.2009
22 Rep. Gr.30 - Clutch