Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
❑ Check the pull-springs and rivet connections ⇒ page 23
❑ Check the wire ring or metal ring ⇒ page 24
❑ Only replace together with clutch plate
❑ Allocation, refer to the electronic parts catalog ETKA
❑ Contact surface for clutch lining must be free of grooves, oil and grease
4 -
Bolt
❑ M6 - 13 Nm
❑ M7 - 20 Nm
❑ Loosen and tighten one after another in 90° increments
Identification of Self-Adjusting Clutch (Sachs)
Pressure plate with stop (locator) -arrow-.
Checking Ends of the Diaphragm Spring
• Wear up to half the thickness of the diaphragm spring
-arrows- is permitted.
Checking the Pull-Springs and Rivet Connection
I - Pull-springs OK
Audi TT 2007 ➤
Manual Transmission - Edition 10.2009
2. Description and Operation 23
To Next Page
Loading...
