Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
• Slight offset in the outer area -arrows A-.
II - Pull-springs damaged
• The pressure plate must be replaced if the pull-spring is bent
or broken off -arrow B-.
– Make sure the rivet connections -arrows B- fit correctly on all
pull-springs -A-.
• Replace any pressure plates that have loose rivet connections
-arrow B-.
Check the Wire Ring or Metal Ring
– Check the wire ring or metal ring inside the pressure plate for
damage -arrow-.
• Replace any pressure plates that have a broken wire ring or
metal ring.
Removal Instructions for Dual-Mass Flywheel
Note
To prevent damaging the dual-mass flywheel when removing, the
bolts -B- must not be removed using an air or impact driver. Re‐
moval of the bolts is only permissible by hand.
– Turn the dual-mass flywheel -A- so that the bolts are posi‐
tioned centrally to the bores -arrows-.
– When removing the bolts, make sure that no bolt head con‐
tacts the dual-mass flywheel, otherwise it may be damaged
when the bolt is turned further.
Audi TT 2007 ➤
Manual Transmission - Edition 10.2009
24 Rep. Gr.30 - Clutch
To Next Page
Loading...
