Audi TT 2007 - Transmission Housing and Shift Mechanism Assembly Overview

Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
2.12 Transmission Housing and Shift Mechanism Assembly Overview
1 - Bolt
❑ Tightening specification
-7- ⇒ page 219
2 - Flange Shaft with Spring
❑ Removing and instal‐
ling, refer to
⇒ “5.2 Transmission
without Circlip A for
Cap/Input Shaft”,
page 131
❑ Assembling, refer to
⇒ “1.3 Differential As‐
sembly Overview”, page
222
3 - Securing Ring
❑ For the sealing cap -4-\
❑ Installed from transmis‐
sion build date 1/21/08
4 - Sealing Cap
❑ Secured with circlip
from transmission build
date 1/21/08
❑ Removing and installing
without circlip, refer to
⇒ “5.2 Transmission
without Circlip A for
Cap/Input Shaft”,
page 131
❑ Removing and installing
with circlip, refer to
⇒ “5.3 Transmission
with Circlip A for the
Cap/Input Shaft”,
page 142
❑ Allocate components,
refer to the electronic
parts catalog ETKA.
5 - Securing Ring
❑ For the grooved ball bearing/input shaft -1- ⇒ page 179
6 - Backup Light Switch -F4-
❑ 20 Nm
7 - Oil Seal
❑ Replace
8 - Bolt for Oil Drain Bore
❑ Tightening specification, refer to ⇒ “3.2 Manual Transmission Oil Filler Plug”, page 87
9 - Oil Seal
❑ Replace
10 - Locking Bolt
❑ 45 Nm
❑ For selector shaft
11 -
Audi TT 2007 ➤
Manual Transmission - Edition 10.2009
2. Description and Operation 77