Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
– Fill space between sealing lip and dust lip -arrow- halfway with
sealing grease -G 052 128 A1- .
– Lightly oil outer circumference of new shaft seal.
– Drive in the shaft sealing ring to the stop.
– Check the transmission oil level in the manual transmission
and fill. Refer to
⇒ “1.1 Manual Transmission, Checking Gear Oil Level”, page
47 .
3.4 Right Flange Shaft
Special tools and workshop equipment required
♦ Used Oil Collection and Extraction Device -V.A.G 1782-
♦ Puller -T10037-
♦ Socket and Extended Bit -T10107 A-
Removing
– Mark the installation positions of nuts -arrows- with a felt-tip
pen.
– Remove the right drive axle. Refer to ⇒ Suspension, Wheels,
Steering; Rep. Gr. 40 ; Removal and Installation .
– Remove right drive axle heat shield from bevel box -arrows-.
– Place -V.A.G 1782- under transmission.
Audi TT 2007 ➤
Manual Transmission - Edition 10.2009
230 Rep. Gr.39 - Final Drive, Differential
To Next Page
Loading...
