Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
– Remove bolts -1 through 3- and remove pendulum support.
Installing
Install in reverse order, paying attention to the following:
• Tightening specifications, refer to
⇒ “2.9 Subframe Mount Assembly Overview”, page 72 .
Note
♦
The holes for the pendulum support on transmissions from
05.28.07 have threaded inserts (for example HeliCoil).
♦
How to recognize: collar on the first thread -arrow-.
♦
Note the correct mounting bolts and tightening specifications
⇒ page 72 .
– First tighten pendulum support on transmission -arrow B- and
-arrow C- and then on subframe -arrow A-.
4.11 Bevel Box, Removing
Special tools and workshop equipment required
♦ Socket and Extended Bit -T10107 A- (SW 6 mm)
♦ Hex Ball Socket -3247-
♦ Bracket -2024 A /1-
Removing
– Remove front wheels.
Audi TT 2007 ➤
Manual Transmission - Edition 10.2009
118 Rep. Gr.34 - Controls, Housing
To Next Page
Loading...
