Audi TT 2007 - Selector Mechanism

Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
– Disconnect electrical connector on trim.
– Fold trim -3- up over shift knob.
– Open clamping sleeve -1- and remove shift knob -2- together
with shift lever boot and trim -3-.
– Disconnect shift lever boot and center console trim -3-
⇒ page 55
Installing
Install in reverse order, paying attention to the following:
– Press shift knob onto shift lever as far as stop.
– Secure shift knob to shift lever with a new clamp -1- using -
V.A.G 1275- .
4.2 Selector Mechanism
Removing
– Remove shift knob with center console trim. Refer to
⇒ “4.1 Shift Knob with Shift Lever Boot”, page 90 .
– Remove the center console. Refer to ⇒ Body Interior; Rep.
Gr. 68 ; Removal and Installation .
– Remove the noise insulation over the shift mechanism.
– Remove nuts -arrows-.
– Completely remove the air filter housing. Refer to ⇒ Fuel In‐
jection and Ignition; Rep. Gr. 24 ; Removal and Installation .
– Remove retaining plate -1- for the shift cable and remove the
control cable from the pin.
Metal selector relay lever:
– Remove retaining plate -2- for the selector cable from the se‐
lector relay lever and remove the control cable from the pin.
Audi TT 2007 ➤
Manual Transmission - Edition 10.2009
4. Removal and Installation 91