3 Removal and Installation
⇒ “3.1 Left Flange Shaft”, page 228
⇒ “3.2 Left Flange Shaft Seal”, page 228
⇒ “3.3 Shaft Sealing Ring for Bevel Box with Manual Transmission
Installed, Replacing”, page 229
⇒ “3.4 Right Flange Shaft”, page 230
⇒ “3.5 Right Flange Shaft Seat on Outer Bevel Box, Replacing”,
page 231
⇒ “3.6 Right Flange Shaft Needle Bearing”, page 232
⇒ “3.7 Seal between Transmission and Bevel Box”, page 233
⇒ “3.8 Bevel Box Drive Flange Seal”, page 234
3.1 Left Flange Shaft
Special tools and workshop equipment required
♦ Oil Collecting and Extracting Device -V.A.G 1782-
Removing
– Remove left drive axle. Refer to ⇒ Suspension, Wheels,
Steering; Rep. Gr. 40 ; Removal and Installation .
– Place -V.A.G 1782- under transmission.
– Remove the left flange shaft bolt by installing 2 bolts in the
flange and counter holding the flange shaft with the assembly
lever.
– Pull out flange shaft with spring.
Installing
• Tightening specification, refer to
⇒ “1.1 Flange Shaft and Seals on Transmission Assembly
Overview”, page 219 .
Install in reverse order, paying attention to the following:
– Press flange shaft against spring force and tighten.
– Install left drive axle. Refer to ⇒ Suspension, Wheels, Steer‐
ing; Rep. Gr. 40 ; Removal and Installation .
– Check the transmission oil level in the manual transmission
and fill. Refer to
⇒ “1.1 Manual Transmission, Checking Gear Oil Level”, page
47 .
3.2 Left Flange Shaft Seal
Special tools and workshop equipment required
♦ Thrust Piece -3305-
♦ Pulling Hook -T20143/2-
♦ Sealing grease -G 052 128 A1-
Procedure
• Transmission installed.
– Remove left drive flange. Refer to
⇒ “3.1 Left Flange Shaft”, page 228 .
Audi TT 2007 ➤
Manual Transmission - Edition 10.2009
228 Rep. Gr.39 - Final Drive, Differential