Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
– Remove the bolt -arrow- for the oil filler hole in the manual
transmission.
• Target value: the fluid level must reach the lower edge of the
oil filler hole.
– Add gear oil if necessary.
– Tighten the bolt for the oil filler hole with a new sealing ring.
– Install the noise insulation. Refer to ⇒ Body Exterior; Rep. Gr.
66 ; Removal and Installation .
1.2 Gear Oil in Bevel Box, Checking
Note
♦
Bevel box is installed to the side of manual transmission and
has a separate self-contained oil system.
♦
Axle oil specification, refer to the electronic parts catalog ET‐
KA.
Special tools and workshop equipment required
♦ Used Oil Collecting and Extracting Device -V.A.G 1782-
Procedure
• Vehicle must be level
• Bevel box must be in installation location.
• Tightening specification, refer to
⇒ “3.1 Bevel Box Oil Filler Bolt”, page 87 .
– Remove noise insulation in center by loosening fasteners
-1 through 4-.
– Place the -V.A.G 1782- under the bevel box.
Audi TT 2007 ➤
Manual Transmission - Edition 10.2009
48 Rep. Gr.34 - Controls, Housing
To Next Page
Loading...
