Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
– Install the clutch position sensor at the clutch master cylinder
and engage -arrow-.
– Connect harness connector -4-.
4.6 Master Cylinder
Special tools and workshop equipment required
♦ Pliers -T10005-
Removing
Note
♦
Before replacing the clutch slave cylinder, perform a function
test first. Refer to
⇒ “1.3 Information Regarding the Removal and Installation of
the Clutch Master or Slave Cylinder”, page 13 .
♦
When performing work in the footwell, place rags on the floor
covering to protect it from brake fluid spills.
– Remove the mounting bracket. Refer to
⇒ “4.4 Mounting Bracket”, page 34 .
– Release actuator rod mounting clip in clutch pedal with -
T10005- .
Audi TT 2007 ➤
Manual Transmission - Edition 10.2009
4. Removal and Installation 37
To Next Page
Loading...
