Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
2.17 Shift Forks Assembly Overview
1 - Rubber Damper
❑ Can be pulled out of se‐
lector rod and inserted
by hand
2 - Selector Rod with Shift Fork
for 1st and 2nd Gear
3 - Selector Rod with Shift Fork
for 3rd and 4th Gear
4 - Selector Rod with Shift Fork
for 5th and 6th Gear
❑ Also serves as the bear‐
ing for the reverse gear
shift fork as of transmis‐
sion build date 5/25/09
5 - Reverse Gear Shift Fork
❑ from transmission man‐
ufacture date 06 03 6,
ball sleeve -6- has been
omitted
❑ Sliding omission
❑ Reverse gear shift fork
is adapted
❑ From transmission build
date 5/25/09, bearing on
the selector rod for the
shift fork for 5th and 6th
gear
❑ Reverse gear shift fork
differentiation
⇒ page 86
❑ Allocation, refer to the
electronic parts catalog
ETKA
6 - Ball sleeve
❑ No longer used as of transmission build date 3/06/06
❑ Sliding omission
❑ Allocation, refer to the electronic parts catalog ETKA
❑ Pulling out ⇒ page 152
❑ Installing ⇒ page 152
Reverse Gear Shift Fork Differentiation
Dimension “a”
mm
Transmission
Manufacture
Date
Reverse Gear
Shift Fork
Mounting
24 Through
05 03 6
With ball
sleeve
On the axle for
the reverse gear
shift fork
⇒ page 84
18 From 3/6/06
to 5/24/09
Without ball
sleeve
15 From 5/25/09 Without ball
sleeve
Selector rod
with shift fork for
5th and 6th gear
⇒ page 147
Audi TT 2007 ➤
Manual Transmission - Edition 10.2009
86 Rep. Gr.34 - Controls, Housing
To Next Page
Loading...
