Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
– Tighten 4 bevel box connecting bolts -arrows- (only 3 shown
in illustration) at manual transmission. Tightening specifica‐
tions -10- ⇒ page 220 .
– Install right flange shaft. Refer to
⇒ “1.2 Flange Shaft and Seals on Bevel Box Assembly Over‐
view”, page 220 .
5.4 Shift Forks
Special tools and workshop equipment required
♦ Thrust Plate -VW 402-
♦ Punch -VW 411-
♦ Sleeve -VW 423-
♦ Thrust Pad 16.5/28 mm Dia. -VW 431-
♦ -1- Kukko 21/3 internal puller
♦ -4- Kukko 22/1 counter-support
Pulling Off Ball Sleeve for Reverse Gear Shift Fork
A - Internal puller 18 to 23 mm , for example -Kukko 21/3-
B - Support , for example -Kukko 22/1-
Pressing In Ball Sleeve for Reverse Gear Shift Fork
5.5 Transmission Housing
Special tools and workshop equipment required
Audi TT 2007 ➤
Manual Transmission - Edition 10.2009
152 Rep. Gr.34 - Controls, Housing
To Next Page
Loading...
