Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
♦ Guide Pin -VW 436 A-
♦ Guide Pin -VW 439-
♦ Slide Hammer-Complete Set -VW 771-
♦ Holding Fixture -VW 801-
♦ Guide Pin -10 - 15-
♦ Thrust Pad -3124-
♦ Driving Sleeve -VW 244 B-
♦ Thrust Plate -VW 401-
♦ Thrust Plate -VW 402-
♦ Punch -VW 407-
♦ Sleeve -VW 416 B-
♦ Driver -3264-
♦ Subframe Support Assm. Device -3290-
♦ Drift -T10168-
♦ Drift -T10169-
♦ Thrust piece -T10203-
♦ Kukko 21/2 Internal puller and Kukko 21/4
♦ Kukko 22/2 counter-support
♦ Drift -T10362-
Removing Cap -A-
– Knock rubber through at center of sealing cap using a screw‐
driver -B- and pry out cap in direction of -arrow-.
Driving In Sealing Cap
– Drive in sealing cap up to the stop.
Removing Lock Elbow for Selector Shaft
– Break off the pin in released position.
Audi TT 2007 ➤
Manual Transmission - Edition 10.2009
5. Disassembly and Assembly 153
To Next Page
Loading...
