Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
Procedure
– Secure the -3336- to the clutch housing.
– Adjust support arm on sliding piece with locking pin -arrow-.
• Number of visible holes = 9.
– Lift the transmission with the -VAS 6100- and -3336- .
– Set down the transmission, for example in a transport con‐
tainer.
4.6 Transmission, Securing to Assembly
Stand
Special tools and workshop equipment required
♦ Holding Plate -VW 309-
♦ Holding Fixture -VW 313-
♦ Transmission Support -VW 353-
– Secure transmission to assembly stand with bolts -arrows-.
4.7 Transmission, Installing
Install in reverse order, paying attention to the following:
Audi TT 2007 ➤
Manual Transmission - Edition 10.2009
4. Removal and Installation 107
To Next Page
Loading...
