Audi TT 2007 - Clutch System, Bleeding; Permitted Unless Authorised by AUDI AG. AUDI AG Does Not Guarantee or Accept any Liability

Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
A - Round Outer Contour -arrows- = Clutch Made by Sachs
Assembly overview - clutch made by Sachs. Refer to
⇒ “2.5 Sachs Clutch Assembly Overview”, page 22 .
B - Round Outer Contour -arrows 1- and a Peripheral Depression
-arrow 2- = Clutch Made by LuK
Assembly overview - clutch made by LuK. Refer to
⇒ “2.6 LuK Clutch Assembly Overview”, page 25 .
Round Outer Contour -arrows 1- and a Peripheral Depression
-arrow 2- = Clutch Made by LuK
Assembly overview - clutch made by LuK. Refer to
⇒ “2.6 LuK Clutch Assembly Overview”, page 25 .
1.2 Clutch System, Bleeding
Note
♦ After working on the hydraulic clutch mechanism, the system
must be bled.
♦ During the following procedures, make sure that brake fluid
does not leak onto the longitudinal member or the transmis‐
sion.
♦ Before bleeding, fill the brake fluid reservoir to the max mark‐
ing with brake fluid.
Special tools and workshop equipment required
♦ Brake Filler/Bleeder Unit -VAS 5234-
♦ Brake fluid specifications, refer to ⇒ Brake System; Rep. Gr.
47. ; General Information
Procedure
• Tightening specification, refer to
⇒ “2.3 Hydraulics Assembly Overview”, page 19 .
– Completely remove the air filter housing. Refer to ⇒ Fuel In‐
jection and Ignition; Rep. Gr. 24 ; Removal and Installation .
– Pull the clutch pedal back to the rest position.
– Connect the -VAS 5234- to the brake fluid reservoir.
Audi TT 2007 ➤
Manual Transmission - Edition 10.2009
12 Rep. Gr.30 - Clutch