Audi TT 2007 - Clutch Release Mechanism, Clutch Slave Cylinder Assembly Overview

Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
Bracket Differentiation
Dimension “a” mm Line Version
8 Plastic line
6 Hose/line assembly
2.4 Clutch Release Mechanism, Clutch Slave Cylinder Assembly Overview
1 -
Bolt
❑ Replace
❑ 12 Nm for metal clutch
slave cylinder
❑ 15 Nm for plastic clutch
slave cylinder
❑ Quantity: 3
❑ Carefully tighten diago‐
nally in small stages so
that the clutch slave cyl‐
inder bolting tabs do not
break off
2 - Clutch Slave Cylinder with
Release Bearing
❑ The clutch slave cylin‐
der and release bearing
are one unit and can on‐
ly be replaced together.
❑ Do not wash the bear‐
ing, just wipe it off.
❑ If the bearing is noisy,
replace it together with
the clutch slave cylinder
❑ Removing and instal‐
ling, refer to
⇒ “4.7 Slave Cylinder
with Release Bearing”,
page 39
3 - O-ring
❑ Replace if damaged
❑ Pull onto line connection
❑ Install with brake fluid
4 - Retaining Clip
5 - Vent Screw
❑ Tightening specification -17- ⇒ page 20
6 - Protective Cap
7 - Retaining Clip
8 - Hose/line Assembly or Plastic Line
❑ To the clutch slave cylinder
Audi TT 2007 ➤
Manual Transmission - Edition 10.2009
2. Description and Operation 21