Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
– Raise upper side of spring -A- over selector bracket pins.
• Use a new bearing shell -B-.
– Lubricate bearing shell and shift lever guide bearing.
– Press bearing shell onto shift lever guide bearing as far as
stop.
– Remove selector mechanism from -T10083- .
– Press bearing shell into selector housing -arrows-.
• All 4 retaining tabs -arrows- must engage.
– Raise upper side of spring -A- over selector bracket pins into
guide.
– Insert the lower spring leg into the guide.
– Install the shift lever, shift cable, selector cable and base plate
⇒ page 59 .
– Install the selector mechanism. Refer to
⇒ “4.2 Selector Mechanism”, page 91 .
5.2 Transmission without Circlip A for Cap/
Input Shaft
Transmission without Circlip -A-.
Remove and install the transmission housing, shift mechanism,
input shaft, output shafts, differential bevel box, and selector rods
Special tools and workshop equipment required
♦ Holding Plate -VW 309-
♦ Holding Fixture -VW 313-
♦ Transmission Support -VW 353-
♦ Thrust Tube -VW 455-
♦ Slide Hammer-Complete Set -VW 771-
♦ Kukko 21/1 internal puller
♦ Kukko 17/0 separating tool
♦ Kukko 22/1 counter-support
♦ Bracket -30 - 211 A-
♦ Thrust Piece -T10042-
♦ Drift -T10169-
Audi TT 2007 ➤
Manual Transmission - Edition 10.2009
5. Disassembly and Assembly 131
To Next Page
Loading...
