Audi TT 2007 - Page 136

Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
– Place the shift housing with the shift lever guide on the -
T10083- .
• The shift lever guide rests in the larger recess -arrow- of the -
T10083- .
• The shift lever guide must project out of selector housing as
far as stop.
– Insert spring side -A- from above into guide.
– Pull spring side -B- down and insert it near the guide (in di‐
rection of ball head).
Note
The selector bracket is only partially shown to provide a better
illustration.
– Carefully remove the shift housing with the shift lever guide
from the -T10083- .
– Move the selector bracket in direction of -arrow 1- back to the
stop.
– Lubricate ball head pins.
– Press ball head pins into selector bracket -arrow 2-.
• Guides -A- and tabs -B- must not be damaged.
– Place the shift housing with the shift lever guide in the larger
depression -arrow- of the -T10083- .
• The shift lever guide must project out of selector housing as
far as stop.
Audi TT 2007 ➤
Manual Transmission - Edition 10.2009
130 Rep. Gr.34 - Controls, Housing