Audi TT 2007 - Transmission Housing Assembly Overview

Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
2.14 Transmission Housing Assembly Overview
Note
Attaching transmission to assembly stand ⇒ “4.6 Transmission, Securing to Assembly Stand”, page 107
1 - Transmission Housing
❑ When replacing: adjust
the output shaft and dif‐
ferential, refer to
⇒ “1.4 Adjustment Over‐
view”, page 224
❑ Changes to the grooved
ball bearing/input shaft
mount area -3-
⇒ page 179
❑ Allocate components
shims, refer to the elec‐
tronic parts catalog ET‐
KA.
2 - Sealing Cap
❑ Removing ⇒ page 153
❑ Driving in ⇒ page 153
3 - Bolt
❑ For oil drain plug
❑ Tightening specifica‐
tion, refer to
⇒ “3.2 Manual Trans‐
mission Oil Filler Plug”,
page 87
4 - Oil Seal
❑ Replace
5 - Bolt
❑ For oil filler hole
❑ Tightening specifica‐
tion, refer to
⇒ “3.2 Manual Trans‐
mission Oil Filler Plug”,
page 87
6 - Lock Elbow
❑ For adjustment of shift mechanism, refer to ⇒ “2.8 Shift Mechanism, Adjusting”, page 69
❑ Can be replaced with non-disassembled transmission
❑ Removing ⇒ page 153
❑ Installation location ⇒ page 154
❑ Driving in ⇒ page 154
7 - Bushing for Selector Rods
❑ Pulling out ⇒ page 154
❑ Driving in ⇒ page 154
8 - Lock Sleeve
❑ Pressing off with transmission disassembled ⇒ page 155
❑ Driving off with non-disassembled transmission ⇒ page 155
❑ Lock sleeve differentiation ⇒ page 155
❑ Lock sleeve with shoulder, driving in ⇒ page 156
Audi TT 2007 ➤
Manual Transmission - Edition 10.2009
2. Description and Operation 81