Audi TT 2007 - Page 86

Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
14 - Clutch Slave Cylinder with Release Bearing
15 - Bolt
❑ Tightening specification -1- ⇒ page 21
16 - Bolt
❑ Tightening specification -13- ⇒ page 220
17 - Bolt
❑ Replace
❑ 40 Nm
❑ Quantity: 4
18 - Bevel Box
❑ Removing and installing with transmission installed, refer to ⇒ “4.11 Bevel Box, Removing”, page 118
❑ Removing and installing with transmission removed, refer to
⇒ “5.2 Transmission without Circlip A for Cap/Input Shaft”, page 131
19 - Differential
❑ Disassembling and assembling, refer to ⇒ “4.1 Differential”, page 238
Installation Position of Shafts and Selector Rods in Transmission
1 - Input Shaft
2 - Output Shaft, 1st to 4th Gears
3 - Output shaft 5th/6th and reverse gear
4 - Reverse Shaft
A - Selector rod for 3rd and 4th gear
B - Selector rod for 1st and 2nd gear
C - Selector rod for 5th and 6th gear
D - Reverse gear shift fork
1)
1)
From transmission build date 5/25/09, bearing on the selector
rod for the shift fork for 5th and 6th gear -C-. Difference, reverse
gear shift forks
⇒ page 86
Audi TT 2007 ➤
Manual Transmission - Edition 10.2009
80 Rep. Gr.34 - Controls, Housing