Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
♦ Thrust Piece -T40008-
♦ Torque Wrench -V.A.G 1331-
♦ Heat Gun -V.A.G 1416-
♦ Used Oil Collecting and Extracting Device -V.A.G 1782-
♦ Extractor Lever -VW 681-
♦ Socket and Extended Bit -T10107 A-
Disassembling
• Transmission removed, refer to
⇒ “4.4 Transmission, Removing”, page 96 and secured to the
assembly stand
⇒ “4.6 Transmission, Securing to Assembly Stand”,
page 107 .
– Rotate transmission in assembly stand with oil drain plug
downward.
– Place the -V.A.G 1782- under the transmission.
– Drain gear oil from manual transmission.
– Remove the right flange shaft bolt using the -T10107 A- .
– Remove 4 bevel box connecting bolts -arrows- (only 3 shown
in illustration) at manual transmission.
– Carefully press bevel box off manual transmission while pro‐
tecting it against falling through.
– Remove bolts -arrows-.
– Remove the clutch slave cylinder together with release bear‐
ing -A-.
Audi TT 2007 ➤
Manual Transmission - Edition 10.2009
132 Rep. Gr.34 - Controls, Housing
To Next Page
Loading...
