Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
Pull Needle Bearing Off Clutch Housing
A - Support , for example -Kukko 22/2-
B - Internal puller 23.5 to 30 mm , for example -Kukko 21/4-
Note
Needle bearing is destroyed when it is removed and must be re‐
placed.
Pressing In Needle Bearing into Clutch Housing
– During pressing sequence, place thrust washer -B- for reverse
shaft onto the needle bearing -A-.
Press Axle for Reverse Gear Shift Fork into Clutch Housing
Audi TT 2007 ➤
Manual Transmission - Edition 10.2009
5. Disassembly and Assembly 159
To Next Page
Loading...
