Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
– Remove bolt -arrow A- and remove left front footwell vent -1-.
– Unclip wiring guide behind footwell vent -1- and lay aside.
– Remove impact bolster -2- secured with one or two bolts
-B arrows- depending on the version.
– Remove clutch pedal -1- from mounting bracket -3-, to do so
remove nut -2- and pull out bolt -5-.
Note
The clutch pedal remains engaged on the clutch master cylinder
actuator rod.
– Swivel clutch pedal slightly downward and remove over-center
spring -4- from mounting bracket.
Installing
• Tightening specification, refer to
⇒ “2.2 Pedal Assembly, Master Cylinder Assembly Overview
”, page 17 .
Install in reverse order, paying attention to the following:
Note
♦
Replace self-locking nut.
♦
Lubricate the various bearing and contact surfaces with
grease -G 000 450 02- .
Audi TT 2007 ➤
Manual Transmission - Edition 10.2009
4. Removal and Installation 31
To Next Page
Loading...
