Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
14 - Supply Hose
❑ To brake fluid reservoir
❑ Made of rubber or plastic depending on the version
❑ Plastic return hose with additional seals ⇒ page 20
15 -
Nut
❑ Replace
❑ 20 Nm
❑ Self-locking
❑ Quantity: 3
❑ For the bracket to the bulkhead
16 - Nut
❑ Replace
❑ 25 Nm
❑ Self-locking
17 - End stop
❑ For clutch pedal
Impact Bolster - Tightening Specification
– Insert impact bolster -2- and tighten 1 or 2 screws -B arrows-
depending on the version.
• M6: 10 Nm
• M8: 20 Nm
Replace Clutch Pedal Cap
– Trim the new clutch pedal cap as shown in the figure.
• Dimension -x- 20 mm
Audi TT 2007 ➤
Manual Transmission - Edition 10.2009
18 Rep. Gr.30 - Clutch
To Next Page
