Audi TT 2007 - Page 131

Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
Plastic selector relay lever -1-:
– Pull the securing mechanism forward as far as the stop in the
direction of -arrow 1- and then unlock to the left in the direction
of -arrow 2-.
– Press the selector relay lever forward in direction of
-arrow 3- while pulling the selector cable out of the control ca‐
ble retainer.
– Remove the selector relay lever with catch to Model Year 2007
⇒ page 64
– Remove the selector relay lever with catch from Model Year
2008 ⇒ page 69
Metal selector relay lever
– Pull off securing clip -2- and press selector relay lever -3- to
the side and out of the bearing.
All Vehicles
Note
If the selector relay lever cannot be removed due to the trans‐
mission bracket, remove the selector cable from the selector relay
lever. Remove the slide shoe from the transmission shift lever.
– Remove nut -4- and remove transmission shift lever -1-.
– Pry out the shaft sealing ring using the -T20143/1- .
– Lightly oil outer circumference of new shaft seal.
– Drive in new shaft seal as far as stop without tilting it.
– Fill area between sealing lip and dust lip -arrow- halfway with
sealing grease -G 052 128 A1- .
Audi TT 2007 ➤
Manual Transmission - Edition 10.2009
4. Removal and Installation 125