Audi TT 2007 - Page 133

Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
– Move shift shaft to neutral position.
Caution
In the following step, ensure that the selector shaft is not locked
by the lock elbow -arrow-.
– Remove back-up light switch -F4- -1-.
– Remove mounting bolt -2-.
– Remove the bolts -3-.
– Remove selector shaft with shift cover -4- from transmission
housing.
Installing
• Tightening specification, refer to
⇒ “2.12 Transmission Housing and Shift Mechanism Assem‐
bly Overview”, page 77 ,
⇒ “2.16 Shift Mechanism Assembly Overview, Transmission
Side”, page 85 .
– Press selector shaft -1- against lock sleeve in direction of-2-
-arrow- and guide downward with shift finger -3- through shift
forks until stop.
• Shift cover -4- must stand parallel to bolting surface on trans‐
mission housing during this.
• Selector shaft must be able to be moved easily in selector
motion (up- and downward).
Note
If shift cover stands at an angle to bolting surface, selector shaft
is not inserted in lower bearing.
– Tighten the bolts -3- for the shift cover -4-.
– Install lock bolt -2-. Lock elbow -arrow- must not be installed
when doing so.
– Install back-up light switch -F4- -1-.
– Install the transmission shift lever and selector relay lever. Re‐
fer to
⇒ “2.6 Transmission Shift Lever and Selector Relay Lever to
Model Year 2007 Assembly Overview”, page 63 or
⇒ “2.7 Shift Cable and Selector Cable from Model Year 2008
Assembly Overview ”, page 65 .
Note
The transmission shift lever can only be inserted in one position.
– Install the air filter housing. Refer to ⇒ Fuel Injection and Ig‐
nition; Rep. Gr. 24 ; Removal and Installation .
Audi TT 2007 ➤
Manual Transmission - Edition 10.2009
4. Removal and Installation 127