Audi TT 2007 - Page 41

Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
Removing
Note
While performing the following work, make sure that no brake fluid
comes into contact with longitudinal member or with the trans‐
mission. If this happens, these areas must be cleaned thoroughly.
– Clamp off the return hose to the clutch master cylinder with a
-3094- .
– Remove the return hose from the clutch master cylinder by
releasing spring clamp -3- with the -VAS 6340- if necessary.
– Release securing clip -2- with a screwdriver and pull off hose/
line assembly -1- or plastic line from the clutch master cylinder.
– Unclip the clutch position sensor -G476- at the clutch master
cylinder -arrow- and remove with harness connector -4- still
connected.
– Slide driver's seat as far to the rear as possible and set steer‐
ing wheel to the highest position.
– Remove the driver side storage compartment. Refer to ⇒
Body Interior; Rep. Gr. 68 ; Removal and Installation .
– Remove bolt -arrow A- and remove left front footwell vent -1-.
– Unclip wiring guide behind footwell vent -1- and lay aside.
– Remove impact bolster -2- - secured with one or two bolts
-B arrows- depending on the version.
Note
When performing work in the footwell, place rags on the floor
covering to protect it from brake fluid spills.
Audi TT 2007 ➤
Manual Transmission - Edition 10.2009
4. Removal and Installation 35