Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
• The shoulder on the inner diameter of the -3005- points toward
the outer ring.
Pulling Off Inner Race for Tapered Roller Bearing
– Place the -40-105- on the differential housing.
– Tension the puller for example -Kukko 204/2- in the area of the
flattened sides of the differential housing below the inner ring.
Note
When pulling off inner race, make sure that the hooks do not bend
outward; if necessary re-tighten bolt -arrow-.
Pressing On Tapered Roller Bearing Inner Race
Pulling Off Inner Race for Tapered Roller Bearing
A - Extractor , for example -Kukko 18/1-
B - Separating device 12 to 75 mm , for example -Kukko 17/1-
Pressing on Tapered Roller Bearing Inner Race
Audi TT 2007 ➤
Manual Transmission - Edition 10.2009
4. Disassembly and Assembly 239
To Next Page
Loading...
