Audi TT 2007 - Page 246

Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
– Place the sleeve -3301/3- from the -3301- with the notch
-arrow- (larger inner diameter) on the inner race for the tapered
roller bearing.
Pulling Outer Race/Tapered Roller Bearing Out of Transmission
Housing
A - Support , for example -Kukko 22/2-
B - Internal puller 46 to 58 mm , for example -Kukko 21/7-
Pressing in Tapered Roller Bearing Outer Race Into Transmission
Housing
– Support transmission housing directly beneath bearing mount
using -3345- .
Removing the Differential Bevel Gear Axle and Spring Pin
– First drive roll pin -1- flush into differential bevel gear axle
-2-.
– Place differential with roll pin -arrow- facing toward -30 - 23-
below press.
– Then press out differential bevel gear axle.
Note
Remove sheared of parts of roll pin from differential bevel gear
axle if necessary.
Installing the Differential Bevel Gears
– Insert thrust washer union with transmission fluid.
– Insert both large differential bevel gears and secure (for ex‐
ample with flange shaft).
– Insert the small differential planetary gears 180° offset and
pivot them into position.
Audi TT 2007 ➤
Manual Transmission - Edition 10.2009
240 Rep. Gr.39 - Final Drive, Differential