Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
– Press in the differential bevel gear axle -arrow A- up to the first
small differential bevel gear.
– Insert threaded pieces -arrows B- in large differential bevel
gears.
• Installed position: shoulder faces the differential bevel gear
– Drive differential planetary gear axle into final position and se‐
cure with spring pin ⇒ page 241 .
Roll Pin, Installing
– Drive new roll pin -arrow- flush into differential bevel gear axle
with a drift -1-.
A005TT016-031510
Audi TT 2007 ➤
Manual Transmission - Edition 10.2009
4. Disassembly and Assembly 241
To Next Page
Loading...
