Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
– Disconnect electrical harness connector -1- for back-up light
switch -F4- .
– Remove the ground (GND) cable -2-.
– Then remove upper starter mounting bolt under ground (GND)
cable -2-.
– Disconnect electrical connector -3-.
– Slide cover -4- back.
– Disconnect the electrical wire -arrow- from the starter.
– Remove upper engine/transmission bolts -arrows-.
– Install -T10338- on open threaded hole at left rear of engine.
Audi TT 2007 ➤
Manual Transmission - Edition 10.2009
4. Removal and Installation 99
To Next Page
Loading...
