Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
– Press in the tapered roller bearing outer ring with the deter‐
mined adjustment shim (1.65 mm as an example). Support
transmission housing directly beneath bearing mount using
-2050- .
Checking Measurement
• Determined adjustment shim installed.
– Install measuring tools. Insert washers with a total thickness
of 8 mm at securing bolt -arrow- for -VW 792- at clutch housing.
– Set dial gauge -VAS 6080- (3 mm measuring range) to zero
with 1 mm preload.
– Loosen securing bolts for clutch housing/transmission housing
in diagonal sequence until bolts clear transmission housing
and output shaft.
• For a correctly selected adjustment shim, the dial gauge must
now display a value of 0.15 mm to 0.25 mm.
Audi TT 2007 ➤
Manual Transmission - Edition 10.2009
2. Description and Operation 191
To Next Page
Loading...
