Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
• Groove -arrow- on gear wheel must point upward.
Press on the Grooved Ball Bearing with the Rubber Ring
• In the case of a grooved ball bearing with a rubber ring
-arrow-, the -VW 454- must be installed so that shoulder -A-
points toward the -VW 412- .
Grooved Ball Bearing Installed Position
• Grooved ball bearing installation position: the groove for the
circlip points upward -arrow A- and shoulder -arrow B- must
point toward the 5th gear toothed wheel.
– Then, determine the circlip ⇒ page 193 and install.
Determining Circlip
Audi TT 2007 ➤
Manual Transmission - Edition 10.2009
3. Disassembly and Assembly 193
To Next Page
Loading...
