Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
– Remove output shaft seal -A-.
– Clean any remaining locking fluid from the thread on the shaft
bevel gear.
• Previous shim -2- for shaft beveled gear preload -1- must be
installed.
– Install the taper roller bearing inner race -3- into the outer ring
in the bevel box.
– Lightly apply oil to the outer diameter of the new seal -4- for
the output flange.
– Drive in shaft seal as far as stop with -T10049- .
– Fill area between sealing lip and dust lip halfway with sealing
grease -G 052 128 A1- .
– Pull the output flange in; when doing this mount the pulling
hooks at the bottom of the drive pinion housing.
A - Two–arm puller Kukko 20/10
Audi TT 2007 ➤
Manual Transmission - Edition 10.2009
236 Rep. Gr.39 - Final Drive, Differential
To Next Page
Loading...
