AudioCodes Mediant 500L - Page 1008

User's Manual 1008 Document #: LTRT-10532
Mediant 500L Gateway & E-SBC
Parameter Description
The value can be a string of up to 29 characters.
For more information, see Customizing the Product Name on
page 69.
Note: To enable customization of the device name, see the
UseProductName parameter.
[UseWebLogo] Defines whether the Web interface displays a logo image or text.
 [0] = (Default) The Web interface displays a logo image,
configured by the LogoFileName parameter.
 [1] = The Web interface displays text, configured by the
WebLogoText parameter.
For more information, see Replacing the Corporate Logo on
page 67.
[WebLogoText] Defines the text that is displayed instead of the logo in the Web
interface.
The valid value is a string of up to 15 characters.
For more information, see Replacing the Corporate Logo with
Text on page 68.
Note: The parameter is applicable only when the UseWebLogo
parameter is configured to 1.
[LogoWidth] Defines the width (in pixels) of the logo image that you want
displayed in the Web interface instead of the default logo.
The valid value is 0 to 199. The default is 145.
For more information, see Replacing the Corporate Logo with an
Image on page 67.
Notes:
 The optimal setting depends on your screen resolution.
 If the width of the loaded image is greater than the maximum
value, the device automatically resizes the image to the
default width size.
 The height is limited to 24 pixels.
 The parameter is applicable only when the UseWebLogo
parameter is configured to 0.
 To define the image file, see the LogoFileName parameter.
[LogoFileName] Defines the name of the image file that you want loaded to the
device. This image is displayed as the logo in the Web interface
(instead of AudioCodes logo).
The file name can be up to 47 characters.
For more information, see Replacing the Corporate Logo with an
Image on page 67.
Notes:
 The image file type can be one of the following: GIF, PNG,
JPG, or JPEG.
 The size of the image file can be up to 64 Kbytes.
 The parameter is applicable only when the UseWebLogo
parameter is configured to 0.