Version 7.2 1127 Mediant 500L Gateway & E-SBC
User's Manual 69. Configuration Parameters Reference
Parameter Description
[NotificationIPGroupID]
Defines the IP Group ID to which the device sends SIP NOTIFY MWI
messages.
Note:
This is used for MWI Interrogation. For more information on the
interworking of QSIG MWI to IP, see Message Waiting Indication
on page 579.
To determine the handling method of MWI Interrogation
messages, use the TrunkGroupSettings_MWIInterrogationType,
parameter (in the Trunk Group Settings table).
MWI Notification Timeout
configure voip >
gateway dtmf-supp-
service supp-service-
settings > mwi-ntf-
timeout
[MWINotificationTimeout]
Global parameter defining the maximum duration (timeout) that a
message waiting indication (MWI) is displayed on endpoint
equipment (phones' LED, screen notification or voice tone).
You can also configure the feature for specific calls, using Tel
Profiles (TelProfile_MWINotificationTimeout). For a detailed
description of the parameter or for configuring the feature in the Tel
Profiles table, see Configuring Tel Profiles on page 471.
Note:
The parameter is applicable only to FXS interfaces.
If the feature is configured for a specific Tel Profile, the settings of
the global parameter is ignored for calls associated with the Tel
Profile.
configure voip > gateway
dtmf-supp-service supp-
service-settings > mwi-qsig-
party-num
[MWIQsigMsgCentreldIDParty
Number]
Defines the Message Centred ID party number used for QSIG MWI
messages. If not configured (default), the parameter is not included
in MWI (activate and deactivate) QSIG messages.
The valid value is a string.
Digit Patterns The following digit pattern parameters apply only to voice mail applications that use
the DTMF communication method. For available pattern syntaxes, refer to the CPE Configuration
Guide for Voice Mail.
Forward on Busy Digit Pattern
(Internal)
configure voip > gateway
voice-mail-setting > fwd-bsy-
dig-ptrn-int
[DigitPatternForwardOnBusy]
Defines the digit pattern used by the PBX to indicate 'call forward on
busy' when the original call is received from an internal extension.
The valid range is a 120-character string.
Forward on No Answer Digit
Pattern (Internal)
configure voip > gateway
voice-mail-setting > fwd-no-
ans-dig-pat-int
[DigitPatternForwardOnNoAns
wer]
Defines the digit pattern used by the PBX to indicate 'call forward on
no answer' when the original call is received from an internal
extension.
The valid range is a 120-character string.
Forward on Do Not Disturb
Digit Pattern (Internal)
configure voip > gateway
voice-mail-setting > fwd-dnd-
dig-ptrn-int
Defines the digit pattern used by the PBX to indicate 'call forward on
do not disturb' when the original call is received from an internal
extension.
The valid range is a 120-character string.
To Next Page
Loading...
