Version 7.2 1195 Mediant 500L Gateway & E-SBC
User's Manual 69. Configuration Parameters Reference
Parameter Description
1) When the device handles two calls (an active and a held
call) and this key sequence is dialed, it sends a SIP BYE
message to the active call and the previously held call
becomes the active call.
2) When there is an active call and an incoming waiting
call, if this key sequence is dialed, the device disconnects
the active call and the waiting call becomes an active call.
Flash + 2: Places a call on hold and answers a call-waiting
call, or toggles between active and on-hold calls.
Flash + 3: Makes a three-way conference call. This is
applicable only if the Enable3WayConference parameter is
set to 1 and the 3WayConferenceMode parameter is set to
2. Note that the settings of the ConferenceCode parameter
is ignored.
Flash + 4: Makes a call transfer.
Note: The parameter is applicable only to FXS interfaces.
Flash Keys Sequence Timeout
flash-key-seq-tmout
[FlashKeysSequenceTimeout]
Defines the Flash keys sequence timeout - the time (in msec) that
the device waits for digits after the user presses the flash button
(Flash Hook + Digit mode - when the parameter
FlashKeysSequenceStyle is set to 1 or 2).
The valid range is 100 to 5,000. The default is 2,000.
Keypad Feature - Call Forward Parameters
Forward Unconditional
configure voip > gateway dtmf-
supp-service supp-service-
settings > fwd-unconditional
[KeyCFUnCond]
Defines the keypad sequence to activate the immediate call
forward option.
Forward No Answer
configure voip > gateway analog
keypad-features > fwd-no-
answer
[KeyCFNoAnswer]
Defines the keypad sequence to activate the forward on no
answer option.
Forward On Busy
configure voip > gateway analog
keypad-features > fwd-on-busy
[KeyCFBusy]
Defines the keypad sequence to activate the forward on busy
option.
Forward On Busy or No Answer
configure voip > gateway analog
keypad-features > fwd-busy-or-
no-ans
[KeyCFBusyOrNoAnswer]
Defines the keypad sequence to activate the forward on 'busy or
no answer' option.
Do Not Disturb
configure voip > gateway analog
keypad-features > fwd-dnd
[KeyCFDoNotDisturb]
Defines the keypad sequence to activate the Do Not Disturb
option (immediately reject incoming calls).
To activate the required forward method from the telephone:
4 Dial the user-defined sequence number on the keypad; a dial tone is heard.
To Next Page
Loading...
