AudioCodes Mediant 500L - Page 285

Version 7.2 285 Mediant 500L Gateway & E-SBC
User's Manual 15. Services
Parameter Description
configured hosts. Every consecutive message is sent to the next
available host.
 [1] Sticky Primary = Device always attempts to send traffic to
the first (primary) host. If the host does not respond, the device
sends the traffic to the next available host. If the primary host
becomes available again, the device sends the traffic to the
primary host.
 [2] Sticky Next = Similar to Sticky Primary, but if the primary
host does not respond, the device sends the traffic to the next
available host and continues sending traffic to this host even if
the primary host becomes available again.
Persistent Connection
http-persistent-
connection
[HTTPRemoteServices_Persist
entConnection]
Defines whether the HTTP connection with the host remains open
or is only opened per request.
 [0] Disable = Connection is not persistent and closes when the
device detects inactivity. The device uses HTTP keep-alive
messages to detect inactivity.
 [1] Enable = (Default) Connection remains open (persistent)
even during inactivity. The device uses HTTP keep-alive / HTTP
persistent connection messages to keep the connection open.
Number of Sockets
http-num-sockets
[HTTPRemoteServices_NumOf
Sockets]
Defines how many sockets (connect
ion) are established per remote
host.
The valid value is 1 to 10. The default is 1.
Login
Login Needed
http-login-needed
[HTTPRemoteServices_LoginN
eeded]
Enables the use of proprietary REST API Login and Logout
commands for connecting to the remote host. The commands
verify specific information (e.g., software version) before allowing
connectivity with the device.
 [0] Disable = Commands are not used.
 [1] Enable (default)
Username
rest-user-name
[HTTPRemoteServices_AuthUs
erName]
Defines the username for HTTP authentication.
The valid value is a string of up to 80 characters. The default is
"user".
Password
rest-password
[HTTPRemoteServices_AuthPa
ssword]
Defines the password for HTTP authentication.
The valid value is a string of up to 80 characters. The default is
"password".
Security
TLS Context
rest-tls-context
[HTTPRemoteServices_TLSCo
ntext]
Assigns a TLS Context for connection with the remote host.
By default, no value is defined.
To configure TLS Contexts, see ''Configuring TLS Certificate
Contexts'' on page 113.
Note: The parameter is applicable only if the connection is HTTPS.
Verify Certificate
rest-verify-
Enables certificate verification when connection with the host is
based on HTTPS.