Version 7.2 373 Mediant 500L Gateway & E-SBC
User's Manual 17. Control Network
Parameter Description
ginalCallID]
[0] No = (Default) The device creates a new Call-ID value for the
outgoing message.
[1] Yes = The device uses the same Call-ID value received in the
incoming message for the Call-ID in the outgoing message.
Note: When the device sends an INVITE as a result of a REFER/3xx
termination, the device always creates a new Call-ID value and ignores the
parameter's settings.
Dial Plan
sbc-dial-plan-name
[IPGroup_SBCDialPlan
Name]
Assigns a Dial Plan to the IP Group. The device searches the Dial Plan for
a dial plan rule that matches the source number and if not found, for a rule
that matches the destination number. If a matching dial plan rule is found,
the rule's tag is used in the routing and/or manipulation processes as
source and/or destination tags.
To configure Dial Plans, see Configuring Dial Plans on page 726.
Note: For IP-to-IP Routing rules that are configured for destination based
on tags (i.e., 'Destination Type' parameter configured to Destination Tag),
the parameter is applicable only to the source IP Group and the device
searches the Dial Plan for a dial plan rule that matches the prefix of the
destination number only. For more information on routing based on
destination tags, see Using Dial Plan Tags for Routing Destinations on
page 736.
Tags
tags
[IPGroup_Tags]
Assigns a Dial Plan tag that is used to determine whether the incoming SIP
dialog is sent to this IP Group. The parameter is used when IP-to-IP
Routing rules are configured for destination based on tags (i.e., 'Destination
Type' parameter configured to Destination Tag). For more information on
routing based on destination tags, see Using Dial Plan Tags for Routing
Destinations on page
736.
Call Setup Rules Set ID
call-setup-rules-set-id
[IPGroup_CallSetupRul
esSetId]
Assigns a Call Setup Rule Set ID to the IP Group. The device runs the Call
Setup rule immediately before the routing stage (i.e., only after the
classification and manipulation stages).
By default, no value is assigned.
To configure Call Setup Rules, see Configuring Call Setup Rules on page
405.
Quality of Experience
QoE Profile
qoe-profile
[IPGroup_QOEProfile]
Assigns a Quality of Experience Profile rule.
By default, no value is defined.
To configure Quality of Experience Profiles, see ''Configuring Quality of
Experience Profiles'' on page 325.
Bandwidth Profile
bandwidth-profile
[IPGroup_BWProfile]
Assigns a Bandwidth Profile rule.
By default, no value is defined.
To configure Bandwidth Profiles, see ''Configuring Bandwidth Profiles'' on
page 330.
Message Manipulation
Inbound Message
Manipulation Set
inbound-mesg-
manipulation-set
Assigns a Message Manipulation Set (rule) to the IP Group for SIP
message manipulation on the inbound leg.
By default, no value is defined.
To configure Message Manipulation rules, see Configuring SIP Message
To Next Page
Loading...
