AudioCodes Mediant 500L - Page 695

Version 7.2 695 Mediant 500L Gateway & E-SBC
User's Manual 35. Routing SBC
Parameter Description
parameter is configured to any value other than IP Group. If the
'Destination Type' parameter is configured to IP Group, the
following SIP Interface is used:

Server-type IP Groups: SIP Interface that is assigned to the
Proxy Set associated with the IP Group.

User-type IP Groups: SIP Interface is determined during user
registration with the device.
 For multi-tenancy, if the assigned Routing Policy is not shared
(i.e., the Routing Policy is associated with an Isolated SRD), the
SIP Interface must be one that is associated with the Routing
Policy or with a shared Routing Policy (i.e., the Routing Policy is
associated with one or more Shared SRDs). If the Routing Policy
is shared, the SIP Interface can be one that is associated with
any SRD or Routing Policy (but it's recommended that it belong to
the same SRD/Routing Policy or to shared SRD/Routing Policy to
avoid "bleeding").
Destination Address
dst-address
[IP2IPRouting_DestAddress]
Defines the destination address to where the call is sent. The
address can be an IP address or a domain name (e.g., domain.com).
If ENUM-
based routing is used (i.e., the 'Destination Type' parameter
is set to ENUM) the parameter defines the IP address or domain
name (FQDN) of the ENUM service, for example, e164.arpa,
e164.customer.net or NRENum.net. The device sends the ENUM
query containing the destination phone number to an external DNS
server, configured in the IP Interfaces table. The ENUM reply
includes a SIP URI (user@host) which is used as the destination
Request-URI in this routing table.
The valid value is a string of up to 50 characters (IP address or
FQDN). By default, no value is defined.
Note:
 The parameter is applicable only if the 'Destination Type'
parameter is set to Dest Address [1] or ENUM [3]; otherwise, the
parameter is ignored.
 When using domain names, enter a DNS server IP address or
alternatively, define these names in the Internal DNS table (see
''Configuring the Internal SRV Table'' on page 167).
 To terminate SIP OPTIONS messages at the device (i.e., to
handle them locally), set the parameter to "internal".
Destination Port
dst-port
[IP2IPRouting_DestPort]
Defines the destination port to where the call is sent.
Destination Transport Type
dst-transport-type
[IP2IPRouting_DestTransport
Type]
Defines the transport layer type for sending the call:
 [-1] = (Default) Not configured - the transport type is determined
by the SIPTransportType global parameter.
 [0] UDP
 [1] TCP

[2]
TLS
IP Group Set
ipgroupset-name
[IP2IPRouting_IPGroupSetNa
Assigns an IP Group Set to the routing rule. The device routes the
call to one of the IP Groups in the IP Group Set according to the
load-balancing policy configured for the IP Group Set. For more
information, see Configuring IP Group Sets on page 709.