AudioCodes Mediant 500L - Page 696

User's Manual 696 Document #: LTRT-10532
Mediant 500L Gateway & E-SBC
Parameter Description
me]
Note: The parameter is applicable only if you configure the
'Destination Type' parameter to IP Group Set (above).
Call Setup Rules Set ID
call-setup-rules-set-id
[IP2IPRouting_CallSetupRule
sSetId]
Assigns a Call Setup Rule Set ID to the routing rule. The device
performs the Call Setup rules of this Set ID if the incoming call
matches the characteristics of this routing rule. The device routes the
call to the destination according to the routing rule's configured
action, only after it has performed the Call Setup rules.
To configure Call Setup rules, see ''Configuring Call Setup Rules'' on
page 428.
Group Policy
group-policy
[IP2IPRouting_GroupPolicy]
Defines whether the routing rule includes call forking.
 [0] None = (Default) Call uses only this route (even if Forking
Group members are configured in the rows below it).
 [1] Forking = Call uses this route and the routes of Forking Group
members, if configured (in the rows below it).
Note: Each Forking Group can contain up to 20 members. In other
words, up to 20 routing rules can be configured for the same Forking
Group.
Cost Group
cost-group
[IP2IPRouting_CostGroup]
Assigns a Cost Group to the routing rule for determining the cost of
the call.
By default, no value is defined.
To configure Cost Groups, see ''Configuring Cost Groups'' on page
279.
Note:

To implement LCR and its Cost Groups, you must enable LCR for
the Routing Policy assigned to the routing rule (see ''Configuring
SBC Routing Policy Rules'' on page
705). If LCR is disabled, the
device ignores the parameter.
 The Routing Policy also determines whether matched routing
rules that are not assigned Cost Groups are considered as a
higher or lower cost route compared to matching routing rules
that are assigned Cost Groups. For example, if the 'Default Call
Cost' parameter in the Routing Policy is configured to Lowest
Cost, even if the device locates matching routing rules that are
assigned Cost Groups, the first-matched routing rule without an
assigned Cost Group is considered as the lowest cost route and
thus, chosen as the preferred route.
Routing Tag Name
routing-tag-name
[IP2IPRouting_RoutingTagNa
me]
Defines the destination Dial Plan tag, which is used to determine the
destination IP Group.
The default value is "default", meaning that the device uses the first
tag name in the Dial Plan rule that is configured without a value. For
example, if the Dial Plan rule is configured with tags
"Country=England;City=London;Essex", the default tag is "Essex".
For more information, see Using Dial Plan Tags for Routing
Destinations on page page 736.
Note:
 The parameter is applicable only if the 'Destination Type'
parameter is configured to Destination Tag (see above).
 Only one tag can be configured for the parameter.
 Only the tag name must be configured (not the value, if exists).
For example, if the tag is configured in the Dial Plan rule as